59 SERIES GRIND CAMS For 95"+ motors with 10:1 compression ratio or higher Maximum torque and HP at middle and upper rpm ranges (2400-6200 rpm) Coil bind must be checked, but can use stock tappets

• Cams work well with fuel injection or carburetor models
• Run best with low restriction exhausts (1700-5200 rpm)
• Works well with carbs or fuel injection
• Bolt-in cam for more torque with stock compression
• Can be used with stock valve springs and tappets
• Similar to the EV-23 cam
• All Andrews gear-driven cams require four-gear set for installation
• Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
• 59G cams are for highly tuned engines and require the knowledge of an expert engine builder for proper setup and installation.